Sticker Plastic Tape (Cellulose Tape, tape) of decal paper? also it sounds weird huh? yes ..... that's the reality. Tape Sticker decal paper does not require coating like pilox. So pilox clearnya stored first, now trying Tape Sticker decal paper. Actually there was no intention to make weird, just have the idea came out after abis tape, and later often abis. Well look at the tape, the idea of how to make stickers out of tape, what can take pictures when I paste it into the paper tape decal?
After experiencing several failures, I finally managed to move the image of the decal paper to tape. How do I? before you provide some material below.
1. Decal paper
2. Epson printers with anything other than the dye ink (dye ink? No way)
3. Masking tape rolls or sheets
4. Hairdryer
5. To fill the water bowl
6.Gunting / Cutter
How it works:
Ink wear sublime
Pigment ink wear
As usual, keramik88 decal paper products, printing with the printer first. My experiments using Sublime ink and Pigment Ink. Ndak ink instead of another can, I have a printer with ink sublime, artpaper, pigments and lasers. But now a new opportunity to try both types of ink.
Adjust the print area with masking tape to be used. While I put on the tape of a width of 5 cm, so the image I created just 4.5 cm wide. If you have a plastic adhesive paper A4 width or more, you can wear them. Wider, more difficult.
Once the mold is dry, if you want to use a hair dryer can dry quickly. Now begin to glue the tape over the image, the design you have created. Glue a little first on the desk, pull tight tape, paper decal set for the image to be exactly right underneath and diarea wide masking tape.
The arrow indicates the end of the first tape glued over the kitchen work. Masking tape is pulled tight, from the left (in the picture), press the palm of the hand, as he shifted to right, until smooth and do not let anyone gelebung air. If air bubbles occur, puncture with a needle and scrubbed again until blended. If there are air bubbles, meaning the image is not attached to the part, and there was an empty hole in the picture. Take a clean paper HVS or anything to put on an image that has been bonded with tape, rub it with a blunt object, so that the tape glue is stronger and more evenly.
Heat tape surface with a hairdryer, a distance of 1 cm from the surface of the tape. (It should be close) to be more hot and the image will change to a lighter (if using ink sublime). How long? depending on the hairdryer. You try it first, if the ink will fade after the dyed water, means less time heating.
Note the photo above, half-down part in layers of duct tape. the upper (shiny) and has been taped in the heat the hairdryer, the color is bright and clearly visible.
The next step is usually done to decal paper, the scissors, dip into the water, for the better way rather long simmer until slightly floating in the water off the tape. After that lift the tape, let the paper is left in the water (see the photo above). Image is moved to tape. When drying enough, the rest of the decal paper is not visible residual ink left.
Attachment to the Media:
Before you stick masking tape that has been illustrated, rub the surface with a little water evenly, so that the tape-slide can be shifted to fine tune and adjust the position of the image. Attach tape, rub and smooth it with a soft cloth while pressed. To strengthen again to heat the hairdryer. Finish!!
Now depending on your creations, to be applied in any media. Plastic media that had unsatisfactory coating wears sticky and not be overcome in this way. May be useful.
Tidak ada komentar:
Posting Komentar